Davis Vantage Pro weather Station Rain Gauge problems
 

Hi, I get a reading when I tip the bucket manually, its set for mm.
However the readings are either non existant or very low when water is
poured in at a very slow rate or when it raining. On the old Monitor you
had to calibrate but there is no mention of this in the Vantage manual. Any
ideas anyone?

raymond

Davis Vantage Pro weather Station Rain Gauge problems
 

Clocked 59mph on a Maximum wind sensor and 64mph on an Instromet system here
at Pitsford at around 06:21. Anemometers are approx 10m above ground level.

Mike

Pitsford Hall
www.northantsweather.org.uk

"Raymond Jeffery" wrote in message
...
Hi, I get a reading when I tip the bucket manually, its set for mm.
However the readings are either non existant or very low when water is
poured in at a very slow rate or when it raining. On the old Monitor you
had to calibrate but there is no mention of this in the Vantage manual.
Any ideas anyone?

raymond

Davis Vantage Pro weather Station Rain Gauge problems
 

Hi,
I use myself a Vantage Pro 2.
On the Console I can calibrate the rain gauge.
This is explained in the manual p.21
Here rthe link to the console manual for the Vantage Pro 2
http://info-electronics.co.in/davis/...VP2_Manual.pdf

Hope this helps you

Marc

Raymond Jeffery wrote:
Hi, I get a reading when I tip the bucket manually, its set for mm.
However the readings are either non existant or very low when water is
poured in at a very slow rate or when it raining. On the old Monitor
you had to calibrate but there is no mention of this in the Vantage
manual. Any ideas anyone?

raymond